| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
cgroup/dmem: avoid pool UAF
An UAF issue was observed:
BUG: KASAN: slab-use-after-free in page_counter_uncharge+0x65/0x150
Write of size 8 at addr ffff888106715440 by task insmod/527
CPU: 4 UID: 0 PID: 527 Comm: insmod 6.19.0-rc7-next-20260129+ #11
Tainted: [O]=OOT_MODULE
Call Trace:
<TASK>
dump_stack_lvl+0x82/0xd0
kasan_report+0xca/0x100
kasan_check_range+0x39/0x1c0
page_counter_uncharge+0x65/0x150
dmem_cgroup_uncharge+0x1f/0x260
Allocated by task 527:
Freed by task 0:
The buggy address belongs to the object at ffff888106715400
which belongs to the cache kmalloc-512 of size 512
The buggy address is located 64 bytes inside of
freed 512-byte region [ffff888106715400, ffff888106715600)
The buggy address belongs to the physical page:
Memory state around the buggy address:
ffff888106715300: fc fc fc fc fc fc fc fc fc fc fc fc fc fc fc fc
ffff888106715380: fc fc fc fc fc fc fc fc fc fc fc fc fc fc fc fc
>ffff888106715400: fa fb fb fb fb fb fb fb fb fb fb fb fb fb fb fb
^
ffff888106715480: fb fb fb fb fb fb fb fb fb fb fb fb fb fb fb fb
ffff888106715500: fb fb fb fb fb fb fb fb fb fb fb fb fb fb fb fb
The issue occurs because a pool can still be held by a caller after its
associated memory region is unregistered. The current implementation frees
the pool even if users still hold references to it (e.g., before uncharge
operations complete).
This patch adds a reference counter to each pool, ensuring that a pool is
only freed when its reference count drops to zero. |
| In the Linux kernel, the following vulnerability has been resolved:
macvlan: fix error recovery in macvlan_common_newlink()
valis provided a nice repro to crash the kernel:
ip link add p1 type veth peer p2
ip link set address 00:00:00:00:00:20 dev p1
ip link set up dev p1
ip link set up dev p2
ip link add mv0 link p2 type macvlan mode source
ip link add invalid% link p2 type macvlan mode source macaddr add 00:00:00:00:00:20
ping -c1 -I p1 1.2.3.4
He also gave a very detailed analysis:
<quote valis>
The issue is triggered when a new macvlan link is created with
MACVLAN_MODE_SOURCE mode and MACVLAN_MACADDR_ADD (or
MACVLAN_MACADDR_SET) parameter, lower device already has a macvlan
port and register_netdevice() called from macvlan_common_newlink()
fails (e.g. because of the invalid link name).
In this case macvlan_hash_add_source is called from
macvlan_change_sources() / macvlan_common_newlink():
This adds a reference to vlan to the port's vlan_source_hash using
macvlan_source_entry.
vlan is a pointer to the priv data of the link that is being created.
When register_netdevice() fails, the error is returned from
macvlan_newlink() to rtnl_newlink_create():
if (ops->newlink)
err = ops->newlink(dev, ¶ms, extack);
else
err = register_netdevice(dev);
if (err < 0) {
free_netdev(dev);
goto out;
}
and free_netdev() is called, causing a kvfree() on the struct
net_device that is still referenced in the source entry attached to
the lower device's macvlan port.
Now all packets sent on the macvlan port with a matching source mac
address will trigger a use-after-free in macvlan_forward_source().
</quote valis>
With all that, my fix is to make sure we call macvlan_flush_sources()
regardless of @create value whenever "goto destroy_macvlan_port;"
path is taken.
Many thanks to valis for following up on this issue. |
| Double free vulnerability in the krb5_rd_cred function for MIT Kerberos 5 (krb5) 1.3.1 and earlier may allow local users to execute arbitrary code. |
| Use-after-free vulnerability in Sendmail before 8.13.8 allows remote attackers to cause a denial of service (crash) via a long "header line", which causes a previously freed variable to be referenced. NOTE: the original developer has disputed the severity of this issue, saying "The only denial of service that is possible here is to fill up the disk with core dumps if the OS actually generates different core dumps (which is unlikely)... the bug is in the shutdown code (finis()) which leads directly to exit(3), i.e., the process would terminate anyway, no mail delivery or receiption is affected." |
| Double free vulnerability in OpenSSL 0.9.7 allows remote attackers to cause a denial of service (crash) and possibly execute arbitrary code via an SSL client certificate with a certain invalid ASN.1 encoding. |
| Double free vulnerabilities in the error handling code for ASN.1 decoders in the (1) Key Distribution Center (KDC) library and (2) client library for MIT Kerberos 5 (krb5) 1.3.4 and earlier may allow remote attackers to execute arbitrary code. |
| Double free vulnerabilities in error handling code in krb524d for MIT Kerberos 5 (krb5) 1.2.8 and earlier may allow remote attackers to execute arbitrary code. |
| Double free vulnerability in the krb5_recvauth function in MIT Kerberos 5 (krb5) 1.4.1 and earlier allows remote attackers to execute arbitrary code via certain error conditions. |
| Double free vulnerability in gtk 2 (gtk2) before 2.2.4 allows remote attackers to cause a denial of service (crash) via a crafted BMP image. |
| Double free vulnerability in mshtml.dll for certain versions of Internet Explorer 6.x allows remote attackers to cause a denial of service (application crash) via a malformed GIF image. |
| The decompression algorithm in zlib 1.1.3 and earlier, as used in many different utilities and packages, causes inflateEnd to release certain memory more than once (a "double free"), which may allow local and remote attackers to execute arbitrary code via a block of malformed compression data. |
| Double-free vulnerability in CVS 1.11.4 and earlier allows remote attackers to cause a denial of service and possibly execute arbitrary code via a malformed Directory request, as demonstrated by bypassing write checks to execute Update-prog and Checkin-prog commands. |
| Use-after-free in the JavaScript: GC component. This vulnerability was fixed in Firefox 147, Firefox ESR 140.7, Thunderbird 147, and Thunderbird 140.7. |
| In the Linux kernel, the following vulnerability has been resolved:
net: octeon_ep_vf: fix free_irq dev_id mismatch in IRQ rollback
octep_vf_request_irqs() requests MSI-X queue IRQs with dev_id set to
ioq_vector. If request_irq() fails part-way, the rollback loop calls
free_irq() with dev_id set to 'oct', which does not match the original
dev_id and may leave the irqaction registered.
This can keep IRQ handlers alive while ioq_vector is later freed during
unwind/teardown, leading to a use-after-free or crash when an interrupt
fires.
Fix the error path to free IRQs with the same ioq_vector dev_id used
during request_irq(). |
| In BlueZ before 5.55, a double free was found in the gatttool disconnect_cb() routine from shared/att.c. A remote attacker could potentially cause a denial of service or code execution, during service discovery, due to a redundant disconnect MGMT event. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: nf_tables: fix inverted genmask check in nft_map_catchall_activate()
nft_map_catchall_activate() has an inverted element activity check
compared to its non-catchall counterpart nft_mapelem_activate() and
compared to what is logically required.
nft_map_catchall_activate() is called from the abort path to re-activate
catchall map elements that were deactivated during a failed transaction.
It should skip elements that are already active (they don't need
re-activation) and process elements that are inactive (they need to be
restored). Instead, the current code does the opposite: it skips inactive
elements and processes active ones.
Compare the non-catchall activate callback, which is correct:
nft_mapelem_activate():
if (nft_set_elem_active(ext, iter->genmask))
return 0; /* skip active, process inactive */
With the buggy catchall version:
nft_map_catchall_activate():
if (!nft_set_elem_active(ext, genmask))
continue; /* skip inactive, process active */
The consequence is that when a DELSET operation is aborted,
nft_setelem_data_activate() is never called for the catchall element.
For NFT_GOTO verdict elements, this means nft_data_hold() is never
called to restore the chain->use reference count. Each abort cycle
permanently decrements chain->use. Once chain->use reaches zero,
DELCHAIN succeeds and frees the chain while catchall verdict elements
still reference it, resulting in a use-after-free.
This is exploitable for local privilege escalation from an unprivileged
user via user namespaces + nftables on distributions that enable
CONFIG_USER_NS and CONFIG_NF_TABLES.
Fix by removing the negation so the check matches nft_mapelem_activate():
skip active elements, process inactive ones. |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: aloop: Fix racy access at PCM trigger
The PCM trigger callback of aloop driver tries to check the PCM state
and stop the stream of the tied substream in the corresponding cable.
Since both check and stop operations are performed outside the cable
lock, this may result in UAF when a program attempts to trigger
frequently while opening/closing the tied stream, as spotted by
fuzzers.
For addressing the UAF, this patch changes two things:
- It covers the most of code in loopback_check_format() with
cable->lock spinlock, and add the proper NULL checks. This avoids
already some racy accesses.
- In addition, now we try to check the state of the capture PCM stream
that may be stopped in this function, which was the major pain point
leading to UAF. |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: target: iscsi: Fix use-after-free in iscsit_dec_session_usage_count()
In iscsit_dec_session_usage_count(), the function calls complete() while
holding the sess->session_usage_lock. Similar to the connection usage count
logic, the waiter signaled by complete() (e.g., in the session release
path) may wake up and free the iscsit_session structure immediately.
This creates a race condition where the current thread may attempt to
execute spin_unlock_bh() on a session structure that has already been
deallocated, resulting in a KASAN slab-use-after-free.
To resolve this, release the session_usage_lock before calling complete()
to ensure all dereferences of the sess pointer are finished before the
waiter is allowed to proceed with deallocation. |
| In the Linux kernel, the following vulnerability has been resolved:
spi: tegra210-quad: Protect curr_xfer check in IRQ handler
Now that all other accesses to curr_xfer are done under the lock,
protect the curr_xfer NULL check in tegra_qspi_isr_thread() with the
spinlock. Without this protection, the following race can occur:
CPU0 (ISR thread) CPU1 (timeout path)
---------------- -------------------
if (!tqspi->curr_xfer)
// sees non-NULL
spin_lock()
tqspi->curr_xfer = NULL
spin_unlock()
handle_*_xfer()
spin_lock()
t = tqspi->curr_xfer // NULL!
... t->len ... // NULL dereference!
With this patch, all curr_xfer accesses are now properly synchronized.
Although all accesses to curr_xfer are done under the lock, in
tegra_qspi_isr_thread() it checks for NULL, releases the lock and
reacquires it later in handle_cpu_based_xfer()/handle_dma_based_xfer().
There is a potential for an update in between, which could cause a NULL
pointer dereference.
To handle this, add a NULL check inside the handlers after acquiring
the lock. This ensures that if the timeout path has already cleared
curr_xfer, the handler will safely return without dereferencing the
NULL pointer. |
| Use-after-free in the Audio/Video: Playback component. This vulnerability was fixed in Firefox 148, Firefox ESR 115.33, Firefox ESR 140.8, Thunderbird 148, and Thunderbird 140.8. |
